Many water well problems can be easily solved with well pump repair services in Bel Air MD. Water pumps can burn up from low water levels and from the quality of the water that is located within the pool of water. Electrical problems can occur that can make a pump stop working. Attempting to pull the well pump by a homeowner could result in electrical shock or further damage to the pump. It is recommended that a professional repair the pump to limit any further damage. A damaged wire may cause a pump to malfunction or trip the breaker in the fuse panel. If the breaker is turned off and then turned back on and the pump continues to trip the breaker, the pump needs to be checked by a professional.
If the pump is not operating, the motor could need to be repaired or replaced. The on and off switch for a pump can break, and Well Pump Repair Services in Bel Air MD can replace the switch quickly and efficiently. The water can begin flowing again to a home or business. The prime for a well can be lost and needs to be re-primed. If no water is entering a home or business after checking other possible problems, the prime has been lost. When the prime is lost, there’s a good chance the breaker has burned out and needs to be replaced. Only a professional plumber can determine what the cause of the prime being lost is and can check and replace the breaker.
If sand and stones are entering the water system, a plug may be clogged or broken on a pump. The plug would need to be replaced to eliminate this problem. Silt and sand can destroy the water holding tank that the well water enters in a home. Pump problems can be very frustrating in a busy home. A trained plumbing professional can diagnose the problem quickly and replace or repair whatever is not properly working on a pump. There’s no need to be buying water when the water can start flowing immediately after a plumber performs their repairs. For more information on water well repairs, feel free to contact us.
